B737 Pressurization

Consisting on the following elements:

• 1 front panel with engraved texts
• 1 middle panel with holes for components nuts
• 1 back panel with holes for components fitting
• set for analogue gauge

Needed components (optional):

• 1 ON-OFF-ON switch spring loaded to the center
• 1 12 positions rotary switch
• 2 encoders
• 2 sets of 6 displays
• 2 M3x15 bolts
• 10 M3x10 bolts
• 4 spacers 30 mm female-female
• 4 spacers 30 mm male-female
• 2 stops for 4 mm shaft
• 6 M3 nuts
• 4 M3x12 stamped head bolts (black)

Knobs not included.

Recommended (see "accesories" section below):

• 1 servo motor Hitec HS311 or similar (not included in the optional components set).
• 2 printed circuit board for sets of 6 displays
• 2 20-pin IDC connectors for displays