B737 Bleed

Consisting on the following elements:

•     1 front panel with engraved texts
•     1 middle panel with holes for components nuts
•     1 back panel with holes for components fitting
•     13 engraved annunciators (13 front pieces 5 mm thickness + 13 back pieces 3 mm thickness)
• set for analogue gauge

Needed components (optional):

• 2 ON-OFF switches
• 2 black buttons
• 3 locked ON-OFF-ON switches (not available in this site)
• 3 locked ON-OFF switches (not available in this site)
• 18 180 ohms resistors
• 8 470 ohms resistors
• 4 high efficiency blue leds
• 4 high efficiency green leds
• 18 high efficiency amber leds
• 4 M3x12 stamped head bolts (black)
• 6 M3 nuts
• 2 M3x15 bolts
• 4 spacers 30 mm female-female
• 4 spacers 30 mm male-female
• 8 M3x10 bolts
• 2 plastic washers for M3
• 1 stop for 8 mm shaft

Servomotors not included.

Recommended (see "accesories" section below):

• 2 servo motors Hitec HS311 or similar (not included in the optional components set).