B737 EFIS

Consisting on the following elements:

• 1 front panel with engraved texts
• 1 middle panel with holes for components nuts
• 1 back panel with holes for components fitting
• 7 engraved buttons (7 front pieces 5 mm thickness + 7 back pieces 3 mm thickness)
• 4 legends (RST, CTR, TFC y STD) to be inserted into the control knobs

Needed components (optional). Not needed if you buy the printed circuit board for this panel with its components:

• 9 OMROM B3F 1055 tactile switch or equivalent
• 2 ON-OFF-ON toggle switches
• 2 black pushbuttons
• 4 rotary switches (12 positions, 1 circuit, chamfered shaft)
• 2 CTS288 encoders (shaft with slot)

Knobs not included.

Recommended (see "accesories" section below):

• printed circuit board in order to easily connect components to SimIO control cards
• in the video tutorial we have used 6 groups of three leds for backlighting

In order to build EFIS panel like shown in the video below, you need to order:

• EFIS panel without components
• EFIS PCB with components
• ribbon cable 2 meter
• knobs for EFIS
• 6 strips with 3 leds each
• box for EFIS