B737 PCB for EFIS (v 4)

Control for the following inputs:

• encoders: MINS, BARO
• rotary switches: RANGE, FUNC, MINS, BARO
• tactile switches: FPV, MTRS, TFC, CTR, RST, STD, WXR, STA, WPT, ARPT, DATA, POS, TERR
• Toggle switches: 1 and 2 

Needed components (optional); this kit includes every component to build the panel, so you don't need to add any component when ordering the EFIS panel:

• 2 auxiliary panels to fit the concentric components
• 4 gears
• 2 alluminium shafts (diameter 8 mm; lenght 9.5 cm) with stop piece
• 2 acrylic shafts (diameter 4 mm; length 12.5 cm)
• 2 3x3 mm acrylic shafts (length 7 cm)
• 7 3x3 mm acrylic shafts (length 10.3 cm)
• 2 pieces for centering shafts
• 2 sets for tactile switches
• 1 IDC connector (10 pins, male and female)
• 1 IDC connector (40 pins, male and female)
• 1 pin strip
• 3 2-pins polarized connectors male
• 5 2-pins polarized connectors female
• 2 3-pins polarized connectors female
• 16 pins for previous connectors
• 4 12-positions rotary switches with chanfered shafts
• 2 encoders CTS288 (shaft with slot)
• 2 ON-OFF-ON toggle switches
• 2 black buttons
• 2 tactile switches 12x12 mm
• 7 tactile switches 6x6 mm
• 9 spacers 30 mm (female-female)
• 3 spacers 30 mm (male-female)
• 9 M3x10 bolts
• 3 M3x15 bolts
• 4 M3x12 button head bolts
• 7 plastic washers
• 4 M3 nuts
• 4 M3 stub bolts

It's recommended to use leds strips for backlighting. See Accesories tab. In the video tutorial we have used 6 groups of three leds for backlighting.

Assembly instructions here.

In order to build EFIS panel like shown in the video below, you need to order:

• EFIS panel without components
• EFIS PCB with components
• ribbon cable 2 meter
• knobs for EFIS
• 6 strips with 3 leds each
• box for EFIS