A320 EFIS for copilot (push/pull)

Consisting on the following elements:

• 1 front panel with engraved texts
• 1 middle panel
• 1 back panel with holes for components fitting
• 7 engraved buttons (7 front pieces 5 mm thickness + 7 back pieces 3 mm thickness)
• 1 annunciator
• pieces to build the push/pull function and concentric shafts on baro knob.

You will need to use acetone or Acrifix to glue some pieces together. The video shows those pieces already glued.

Needed components. Can be bought as an option when you buy the PCB for this panel.

• 3 8-positions rotary switches
• 1 encoder
• 2 ON-OFF-ON switches
• 7 tactile switches Onrom 4050 or equivalent
• 9 high efficiency green leds 3 mm.
• 9 470 ohms resistors
• 1 set of 6 7-segments displays and its printed circuit board
• 1 20-pin IDC connector (male + female)

Knobs not included.

Recommended (see "accesories" section below):

• printed circuit board in order to easily connect components to SimIO control cards or Arduino