B737 Autobrakes PCB (v 4)

Consisting on the following elemets:

• 1 printed circuit board

Connections for the following inputs:

• two controls with concentric shafts (encoder + 8 positions rotary switch)
• interruptor rotativo
• ENG and SYS switches
• landing gear lever

and outputs:

• autobrakes panel annunciators
• landing gear annunciators

Needed components (optional); this kit includes every component to build the Autobrakes panel, so you don't need to add any component when ordering the the panel:

• 3 rotary switches (8 positions, 1 circuit).
• 2 EC11 encoders
• 4 OMRON B3F1050 tactile microswitches or equivalent
• 1 (ON)-OFF-(ON) toggle switch
• 6 high efficiency amber leds (3mm, flat top)
• 2 high efficiency green leds (3mm, flat top)
• 6 180 ohms resistors
• 2 470 ohms resistors
• 2 auxiliary panels to install the concentric system (supplied with the autobrakes panel)
• 4 gears
• 8 plastic washeers
• 2 aluminium shafts (8 mm de diameter, 6 cm lenght) with limiting piece
• 2 aluminium shafts (4 mm de diameter, 8 cm lenght)
• 1 acrylic shaft (6 mm diameter) with linking piece
• 2 pieces for centering shafts
• 2 IDC connectors 40 pins (male + female)
• 2 polarized connectors 2 pins (male + female)
• 10 polarized connectors 3 pins (male + female)
• 8 spacers 30 mm (female-female)
• 12 M3x10 bolts
• 9 M3x15 bolts
• 4 M3x12 bolts, color RAL7043
• 9 M3 nuts
• 13 grover washers
• 1 pin strip

The use of leds strips is recommended for backlighting. See "Accesories" tab.

Assembly instructions here.