B787 PCB for EFIS

Control for the following inputs:

• encoders: MINS, BARO, RANGE y sus pulsadores
• rotary switches: PLAN, MINS, BARO
• buttons: FPV, MTRS, WXR, TFC, TERR, SYS, CDU, INFO, CHKL, COMM, ND, ENG, R, L, CANC/RCL, RJCT, CANC, ACPT Y WARNING/CAUTION
• controls CLOCK, MIC, MAP at the glareshield

Needed components (optional); this kit includes every component to build the panel, so you don't need to add any component when ordering the EFIS panel:

• 4 black buttons
• 3 8-positions rotary switches
• 12 OMROM B3F 4050 tactile switches or equivalent
• 2 green leds 5x2 mm and 470 ohms resistors
• 2 pin strips
• 8 jumpers
• 13 polarized connectors 2 pins, female
• 5 polarized connectors 2 pins, male
• 2 polarized connectors 4 pins, female
• 2 polarized connectors 4 pins, male
• 50 pins for polarized connectors
• 2 IDE connectors, 10 pins, male
• 2 IDE connectors, 10 pins, female
• 1 IDE connector, 40 pins, male
• 1 IDE connector, 40 pins, female
• 15 M3x10 bolts
• 7 M3x15 bolts
• 4 M3x25 bolts
• 3 M3 nuts
• 20 acrylic washers for M3
• 6 30 mm standoffs male-female
• 10 30 mm standoffs female-female
• 1 2K ohms resistor
• 3 white leds, 3 mm
• 1 red led, 3 mm and 470 ohms resistor
• 1 amber led, 3 mm and 180 ohms resistor
• 3 EC11 encoders
• 12 acrylix rods 3x3x80 mm
• 2 acrylic shafts, diameter 4 mm, lenght 10 cm
• 2 aluminum shafts, diameter 8 mm, lenght 6 cm
• 2 gears for 8-positions switch
• 2 gears for 8 mm shaft
• 1 linking piece (8-position switch - 6 mm shaft)
• 1 linking piece (encoder - 6 mm shaft)
• 9 white led strips

Assembly instructions here.

In order to build EFIS panel like shown in the video below, you need to order:

• EFIS panel without components
• EFIS PCB with components
• ribbon cable
• knobs for EFIS